DeVillbiss Air Power Company A17913, VR1600E Starting, Recommended Cleaning

STARTING

NOTE: Make sure water supply is turned on.

1. Disengage the safety catch as shown. Depress trigger to allow air to escape and to discharge residual pressure in the pipes.

2.With the trigger depressed, place the

ON-OFF switch in the On position. When starting motor, always keep the trigger depressed.

Risk of fluid injection and laceration. Always engage the trigger lock when gun is not in use. Failure to do so could

cause accidental spraying.

Risk of property damage. If after running unit for a few minutes it does not maintain steady water pressure, turn

unit off to prevent damage to the unit and see the troubleshooting guide for instructions.

RECOMMENDED CLEANING

•On vertical surfaces, work from the bottom upwards.

•Let the detergent sit for 1-2 minutes, DO NOT allow detergent to dry.

•To rinse detergent, apply the high pressure jet, keeping the nozzle at least 10 inches from the surface, work from the bottom up.

SHUTTING DOWN YOUR PRESSURE WASHER

1.Place the ON-OFF switch in the OFF position.

2.Turn off water supply.

3.Pull trigger on spray gun to relieve any water pressure in hose or spray gun.

4.Disconnect water supply hose from water inlet.

5.Disconnect high pressure hose from outlet.

6.If cleaning solution application unit was used, rinse cleaning solution application tank and nozzle thoroughly.

13- ENG A17913