ASSEMBLY
For your own safety, do not connect the machine to the power source until the machine is completely assembled and you read and understand the entire instruction manual.
ASSEMBLY TOOLS REQUIRED
Chuck Key/Wrench (Supplied)
ASSEMBLY TIME ESTIMATE
Assembly for this machine takes less than 30 minutes.
RAISING AND LOWERING THE HANDLE
1.Attach the hub of the handle assembly (A) Fig. 1 to the end of the pinion shaft (B). Fasten the handle to the pinion shaft using the special screw (C) and spring (D).
2.Raise the mortising machine head (E) Fig. 2 to the "up" position by turning the handle (A) clockwise.
NOTE: The handle (A) is
B
A
D
C
Fig. 1
A 
E
B 
Fig. 2
ATTACHING THE HYDRAULIC CYLINDER
Place the head (A) Fig. 3 in the “up” position. Attach the hydraulic cylinder (B) to the two fittings, one located on the back of the head (C) Fig. 3, and the other on the column (D) Fig. 4. Push each end of the hydraulic cylinder on its fitting to secure the cylinder.
A
B 
C
Fig. 3
D
B
Fig. 4
ATTACHING THE TOOL AND CHISEL HOLDER
1.Attach the tool and chisel holder (A) Fig. 5 to the back of the column, using the two M6x1x25mm screws (B) and M6 lockwashers.
2.Fig. 6 illustrates the stored chuck key/wrench (C), bushing (F) for use with extra long chisels, and chisels and bits (E).
B 
A
B 
Fig. 5
E
C
F
A 
Fig. 6
