DeWalt 50-760 Assembly Tools Required, Assembly Time Estimate, Attaching the Casters

UNPACKING AND CLEANING

Carefully unpack the machine and all loose items from the shipping container(s). Remove the rust-preventative oil from unpainted surfaces using a soft cloth moistened with mineral spirits, paint thinner or denatured alcohol. Do not use highly volatile solvents such as gasoline, naphtha, acetone or lacquer thinner for cleaning your machine. After cleaning, cover the unpainted surfaces with a good quality household floor paste wax.

ASSEMBLY

For your own safety, do not connect the machine to the power source until the machine is completely assembled and you read and understand the entire instruction manual.

ASSEMBLY TOOLS REQUIRED

Phillips head screwdriver 12 mm wrench

ASSEMBLY TIME ESTIMATE

30 minutes to 1 hour

This machine is heavy. Use two or more people when lifting.

ATTACHING THE CASTERS

1.Turn the stand (A) upside down (Fig 1).

2.Place a 3/8” lockwasher on the caster stud (B). Screw the caster into the threaded hole on the bottom of the stand. Repeat for the other three casters.

3.Tighten the caster by hand, then secure it with a thin 14mm wrench.

A

B

Fig. 1

ATTACHING THE LEGS TO THE MOTOR/BLOWER ASSEMBLY

1.Place the motor/blower assembly with the motor down (A) Fig. 2.

2.Place a 5/16” flatwasher on the knob (B).

3.Align the holes in the legs (C) with the holes (D) in the motor/blower assembly. The legs should extend up. Insert the knob through hole in the legs (C) and into the threaded hole in the motor/blower assembly (D). Tighten the knob securely.

4.Repeat these steps for all knobs on both legs.

B

C

D

A

Fig. 2

8 - English