ATTACHING THE TOP FILTER BAG
Disconnect the machine from the power source!
1.Place a large 5/16” flatwasher on a 5/16" hex head screw.
2.Position the bracket (A) on the dust collector (Fig. 12).
3.Insert 5/16" hex head screw through the hole in
the bracket, then thread it into the hole in the dust | A |
| |
collector. Tighten securely with a 12mm wrench. |
|
4.Thread the other two screws into the appropriate holes and tighten securely.
5.Insert the rod into the pocket on the filter bag (A) Fig. 13.
6.Insert the rod in the hole in the bracket (B).
7.Work the open end of the filter bag into the top groove of the dust collector drum until it is secure and sealed. Bend and fold, as necessary, the internal bag retainer ring to fit it into place.
8.Attach the other filter bag in the same manner.
Fig. 12
A
B
Fig. 13
ATTACHING THE HOSE TO THE INTAKE PORT
Disconnect the machine from the power source!
Model
NOTE: Place the open end (D) of the intake cap rings around and on the ends of each dust intake port before attaching the hose.
Loosely attach the hose clamp (A) Fig. 14 around one end of the flexible hose (B). Attach the hose to the dust intake port (C). Tighten the hose clamp (A). Attach the remaining clamp to the other end of the flexible hose and to the woodworking machine.
NOTE: Do not operate the dust collector with any dust intake port (C) Fig. 13 uncovered. Place the flat intake cap (E) on the dust intake port (Fig. 14).
D
C
E
A
B
Fig. 14
11 - English
