ATTACHING TOP FILTER BAG
DISCONNECT MACHINE FROM POWER
SOURCE
1.Assemble 5/16” flatwasher (23 mm diam.) onto 5/16” hex head screw.
2.Position bracket (A) to dust collector as shown in Fig. 11.
3.Insert 5/16” hex head screw through hole in bracket and thread into the hole in dust collector. Tighten securely with a 12 mm wrench.
4.Insert rod (A) Fig. 12 into pocket on filter bag.
5.Insert rod (A) into hole in bracket (B).
6.Work open end of filter bag into top groove of dust collector drum until secure and sealed. It will be necessary to bend and fold the internal bag retainer ring to fit it into place.
7.Attach the other filter bag in the same manner.
ATTACHING ACCESSORY HOSE TO INTAKE PORT
DISCONNECT MACHINE FROM POWER
SOURCE BEFORE CONNECTING OR DISCONNECTING HOSE .
Model
NOTE: Place open end (D) of intake cap rings around and onto ends of each dust intake port before attaching the hose.
To assemble the 4” dust collection hose (not supplied) to the motor and blower assembly, loosely attach hose clamp (A) Fig. 13, around one end of flexible hose (B) and assemble the hose to dust intake port (C). Tighten hose clamp (A). Assemble the remaining clamp to the other end of the flexible hose and to the woodworking machine.
NOTE: See “ACCESSORIES” section of this manual.
NOTE: Do not operate the dust collector with any of the holes in dust intake port (C) Fig. 13 uncovered. To cover a hole not being used by a hose, place the flat intake cap
(E) on dust intake port as shown in Fig. 13.
D
E
A 
Fig. 11
A
B
Fig. 12
C
A
B
Fig. 13
12
