| ASSEMBLY |
Tools Required for Assembly | |
1 | - 9/16" socket or open end wrench |
1 | - 1/2" socket or open end wrench |
Unpacking | |
1.Remove all packaging leaving the air compressor on the pallet.
2.Remove and discard the (4) screws holding the air compressor to the pallet.
It may be necessary to brace or support one side of the air compressor when removing the pallet because the air compressor will have a tendency to tip.
3.Carefully remove the air compressor from the pallet.
Assemble Wheels
Screws 
It will be necessary to brace or support one side of the outfit when installing the wheels because the compressor
will have a tendency to tip.
1.Attach wheels with shoulder bolts and nuts as shown.
2.Tighten securely. NOTE: The outfit will sit level if the wheels are properly installed.
The wheels and handle do not provide adequate clearance, stability or support for pulling the unit up and down stairs
or steps. The unit must be lifted, or pushed up a ramp. Assemble Rubber Feet
1.Attach rubber feet with the screws provided as shown in previous figure.
2.Tighten securely.
Rubber Feet
Screw
Nut
Wheel
Shoulder Bolt
9- ENG | A08184 |
