DeWalt A16505, DP2800 To Clean the Water Inlet Filter, To Remove Tires, STORAGE Engine Pump

English

3.	Disconnect the spray wand from the gun.
		Z
4.	Remove the high-pressure nozzle from
	the spray wand. Remove any obstructions
	with the nozzle cleaning tool (Z) provided
	and back flush with clean water.

5. Direct water supply into spray wand to back flush loosened particles for 30 seconds.

6.Reassemble the nozzle to the wand.

7.Reconnect spray wand to gun then turn on water supply.

8.Start pressure washer and place spray wand into high pressure setting to test.

To Clean the Water Inlet Filter

This filter screen (U) should be checked periodically and cleaned if necessary.

1. Remove the filter screen (U) by grasping the end and removing it from water inlet of pump.

2. Clean filter by flushing it with water on both	U
sides.

3.Reinsert filter into water inlet of pump. Cone side faces out.

NOTE: Do not operate pressure washer without filter properly installed.

To Remove Tires

1. Using a 1/8" hex head wrench loosen set screw in hub collar.

2. Slide hub collar from axle and remove the tire.

sTORAGE Engine

Consult the engine instruction manual for the man­facturer's recommendations for storage.

Pump

The manufacturer recommends using a pump protector/winterizer, such as DP80 when storing the unit for more than 30 days and/or when freezing temperatures are expected. DP80 is availabe at the store where the pressure washer was purchased. If a pump protector/ winterizer is not available, RV antifreeze or windshield washer fluid needs to be run through the pump as outlined in the steps below.

NOTE: Using a pump protector/ winterizer, RV antifreeze or wind- shield washer fluid is to provide proper lubrication to the internal seals of the pump regardless of temperature or environment.

1.Obtain a funnel, 6 oz. (172 ml) of RV antifreeze or windshield washer fluid, and 16–36" (91 cm) of garden hose with a male hose connector attached to one end.

CAUTION: Risk of property damage. Use only RV antifreeze. Any other antifreeze is corrosive and can damage pump.

2.Disconnect spark plug wire.

3.Connect length of garden hose to water inlet of pump.

4. Add RV antifreeze or windshield washer fluid to hose as shown.

5. Pull engine starter rope slowly several times until antifreeze/ washer fluid comes out of high- pressure hose connection of pump.

6. Remove garden hose from water inlet of pump.

7. Reconnect spark plug wire.

14