ENGLISH
5.To remove a chisel pull back the retainer (d) and pull the chisel out of the tool holder (e).
D25961
TO FIT A CHISEL WITH GROOVE IN THE SHANK (FIG. 4C)
1.Pull the retainer bolt (i) and turn it by 180° to the unlock position.
2.Hold the chisel in front of the tool holder with the groove (h) facing upwards.
3.Insert the chisel shank into the tool holder (e).
4.Pull the retainer bolt (i) and turn it by 180° back to the lock position.
5.Pull on the chisel to check if it is properly locked. The hammering function requires the chisel to be able to move axially several centimetres when locked in the tool holder.
6.To remove a chisel pull the retainer bolt (i) and turn it by 180° to the unlock position.
Adjusting the Side Handle (fig. 1)
The side handle (f) is assembled on the machine to suit both right- and
WARNING: Always operate the machine with the side handle properly mounted.
1.Loosen the clamp knob (c) and rotate the side handle to the desired position.
2.Lock the side handle in place by tightening the clamp knob (c).
OPERATION
Instructions for Use
WARNING:
•Always observe the safety instructions and applicable regulations.
•Be aware of the location of pipework and wiring.
•Apply a pressure of approx. 20 - 30 kg to the tool. Excessive force does not speed up chiselling but decreases tool performance and may shorten tool life.
IMPORTANT: The tool must be held with two hands at all times when in use.
Horizontal applications (fig. 2A):
Proper hand position requires one hand on the side handle (f) and the other hand on the main handle (b).
Vertical applications (fig. 2B):
Proper hand position requires both hands on the main handle (b).
Switching On and Off (fig. 1)
Switching on: set the on/off switch (a) to position 1.
Switching off: set the on/off switch (a) to position 0.
Demolition, Chasing and Channelling (fig. 1, 2)
1.Select the appropriate chisel, and clean its shank.
2.Insert the chisel and check whether it is properly locked.
3.Fit and adjust the side handle (f) and make sure it is firmly tightened.
4.Hold the tool with two hands on the main handle (b) or one hand on the main handle (b) and one hand on the side handle (f). The tool must be held with two hands at all times when in use. Refer to Proper Hand Postion.
5.Switch on tool to run in continuous operation.
6.Always switch off the tool when work is finished and before unplugging.
Various types of chisels are available as an option.
Only DEWALT recommended accessories should be used with this product.
MAINTENANCE
Your DEWALT power tool has been designed to operate over a long period of time with a minimum of maintenance. Continuous satisfactory operation depends upon proper tool care and regular cleaning
This machine is not
Proper Hand Position (fig. 2)
WARNING: To reduce the risk of serious personal injury, ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal injury, ALWAYS hold securely in anticipation of a sudden reaction.
Accessory Maintenance (fig. 5, 6)
WARNING: These chisels can be reground only a limited number of times. If in doubt, contact your dealer for recommendations.
28
