English
COMPONENTS (FIG. 2)
A. ON/OFF button | F. Mode button |
B. Volume knob | G. Clock button |
C. Antenna | H. Preset button |
D. Hang holes | I. LCD display |
E. Seek/tuner/arrow buttons |
|
FIG. 2 | C |
| |
D | B |
I | |
| A |
To install the battery pack (J), insert the slide pack or tower stem into battery receptical until the battery pack is firmly seated. For the stem pack, be sure that the battery latches are engaged. Refer to Figure 3.
To remove battery pack from the radio, firmly pull up or out depending on the battery type. For the stem pack, press the battery release buttons before pulling firmly. Insert it into the charger as described in the charger section of this manual.
FIG. 3
J
E
OPERATION
E
GF
H
FUEL GAUGE BATTERY PACKS (FIG. 4) |
|
|
| ||
Some DEWALT battery packs include a fuel |
|
|
|
|
|
FIG. 4 |
|
| K | ||
gauge which consists of three green LED lights |
|
|
|
|
|
|
|
|
|
| |
that indicate the level of charge remaining in |
|
|
| ||
|
|
| |||
the battery pack. |
|
|
| ||
WARNING: To reduce the risk of injury, turn unit off and disconnect it from power source before installing and removing accessories, before adjusting or when making repairs.
Installing and Removing the Battery Pack (Fig. 3)
NOTE: For best results, make sure your battery pack is fully charged.
8
To actuate the fuel gauge, press and hold the fuel gauge button (K). A combination
of the three green LED lights will illuminate
designating the level of charge left. When the level of charge in the battery is below the usable limit, the fuel gauge will not illuminate and the battery will need to be recharged.
NOTE: The fuel gauge is only an indication of the charge left on the battery pack. It does not indicate unit functionality and is subject to variation based on product components, temperature and
