DeWalt DCR018 To Install Coin Cell Battery FIG, POWER/VOLUME Adjustment FIG, Mode Function FIG

For more information regarding fuel gauge battery packs, please call 1-800-4-DEWALT (1-800-433-9258) or visit our website www.dewalt. com.

TO INSTALL COIN CELL BATTERY (FIG. 5)

WARNING: Danger of explosion if battery is	3V X 1
incorrectly replaced. When replacing battery,
replace it with the same or equivalent type
CR2032. Observe correct polarity (+ and –) when
replacing batteries. Do not store or carry batteries	CR2032
so that metal objects can contact exposed battery
terminals.

Your radio is equipped with memory capacity in order to store the time and your selected radio stations. When the radio is in the OFF position, this memory capacity is powered by one coin cell battery that is included with the radio.

DANGER: DO NOT INGEST BATTERY; CHEMICAL BURN HAZARD. This product contains a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death.

Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and keep it away from children.

If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.

POWER/VOLUME ADJUSTMENT (FIG. 6)
1. To turn the radio on and off, press the FIG. 6	A
ON/OFF button (A).

2. Turn the dial (B) clockwise to increase the volume. To decrease the volume, turn the dial counterclockwise.

English

1.Turn the screw on the battery door (L) counterclockwise to remove. Screw will remain captive in the door.

2.Press down on the battery door latch and pull to open.

3.Install the coin cell battery (M).

4.Replace the battery door, insert the screw and tighten it clockwise.

FIG. 5

M

L

MODE FUNCTION (FIG. 1)

To choose one of the mode functions (FM1, FM2, AM, or AUX) push the mode button (F) until the desired function is found. For example, if the radio is on FM1, seen in upper left portion of LCD display (I), push the mode button three times to change to AUX.

TUNE OR SEEK FUNCTION (FIG. 1)

There are two tuning methods and one seek method for finding the desired frequency.

NOTE: Put the antenna in the raised position for the best possible

NOTE: To reset the LCD display, clock, and pre-sets, remove the coin cell battery and re-install. Follow this procedure if the screen seems to lock in place.

reception.

To tune:

Briefly press and release the right or left arrow button (E) once to increment the frequency up or down.

9