4085-001
3.Press Select. The printer automatically exits the operator panel menus and prints the partial page.
Note: If the Print Buffer operation is selected while the printer is not in the Waiting state, the printer automatically exits the operator panel menus, but no page is printed.
Note: The system administrator can disable the Print Buffer function by turning the Print Buffer Control setting Off. Print Buffer is not displayed when Print Buffer Control is set to Off.
Activating Hex Trace Debug Mode
The Hex Trace menu function puts the printer in a mode that is used to isolate print job problems. Each byte of information contained in the job is printed in both hexadecimal and character formats. Therefore, all emulation commands (PCL 5, PS 2, PJL, and so on) are printed rather than processed, as is normally done.
To activate hex trace mode, select Hex Trace from the UTILITIES MENU.
To exit hex trace mode, select Reset Printer from the JOB MENU or turn the printer off.
Diagnostics (Mode 1) - Print Tests
Registration
Upon selection, this item will first cause a page to be printed from the requested source, then proceed to a menu screen where the registration can be entered. While the page is printing, the Power indicator should blink and the following screen will be displayed:
Registration Page
Printing
The printer prints the registration page from the requested source. It is assumed that either Letter or A4 is loaded into the requested source.
No buttons are active while the registration page is printing. Once complete, the registration screen is displayed.
Diagnostic Aids
