Paper Feed Pick Arm Assembly with Motor and Paper Path Sensor Removal
1.Remove all covers.
2.Remove power supply. Refer to “Power Supply Removal” on page
3.Remove the frame from the base. Refer to “Frame From Base Removal” on page
4.Remove the two lower screws on the base of the RIP shield.
5.Disconnect the integrated tray connector (J6) from the engine board and disconnect the paper path sensor.
6.Remove the
7.Remove the screw {B} from the paper feed frame assembly.
8.Slide the shaft to the left and remove the pick arm assembly.
9.Disconnect the wire from the paper path sensor and snap the sensor out to remove. When reinstalling, note the routing of the wires and position of spring.
Repair Information
