Lexmark J110, Printer manual Change Ink Cartridges, Change Printheads

4085-001

Use the following steps to enter Flash Engine Code mode:

1.Turn off the printer.

2.Press and hold the buttons identified by the “Power-On Reset Button Functions” on page 3-1.

3.Turn on the printer. Release the buttons once the performing self Test message is displayed.

4.Begin programming the Engine code when the Invalid Engine Code message is displayed.

Change Ink Cartridges

When the cover is opened, the carrier moves to the far left. The user can then replace any combination of ink cartridges. (In this position, the printheads cannot be removed -- only the ink cartridges can be replaced.) When the cover is closed, the carrier returns to the print position. The ink level is on the ink cartridges, so the reported ink level (using NPA or the Menus Page) is automatically updated.

Alternatively, there is a menu item in the Utilities Menu which can be selected to replace an ink cartridge. Select Change Ink Cartridge from the Utilities Menu. Open the cover and the carrier moves to the far left and any combination of cartridges can be replaced.

If an unsupported ink cartridges is installed, an Attendance Message is shown. This can occur if the software keys in the printer and ink cartridge are incompatible, as in the case of an OEM printer using Lexmark-branded ink cartridges.

Change Printheads

Select Change Printhead from the Utilities Menu. Open the cover and the carrier moves to the middle and any combination of printheads can be replaced.

If there is a defective or missing printhead when the cover is open, the carrier automatically moves the printhead change location (without the selection of the menu item).

The printhead life count is kept on the printhead itself, so the reported life level (using NPA or the Menus Page) is automatically updated.

3-4Service Manual