Backup Roller Assembly Removal
1.Remove all covers.
2.Remove carrier and belt. Refer to “Engine Board /Cover Removal” on page
3.Remove pump housing, maintenance station, tank and transport carrier motor. Refer to “Pump Housing/Maintenance Station/Ink Waste Tank/Transport Carrier Motor Removal” on page
4.Remove star wheel shaft. Refer to “Star Wheel Shaft Assembly Removal” on page
5.Remove the paper feed platen. Refer to “Paper Feed Platen Assembly Removal” on page
6.Remove the backup roller springs.
7.Remove the index board assembly. Refer to “Index Card Assembly Removal” on page
8.Remove the encoder disk feed roller assembly. Refer to “Encoder Disk Feed Roller Assembly Removal” on page
9.Remove the frame from the base. Refer to “Frame From Base Removal” on page
10.Disconnect all cable connectors from the engine board.
11.Remove, from the left side frame, two
12.Move the paper feed frame and motor to the right and remove. Refer to “Paper Feed Frame and Motor/Cam Shaft Assembly Removal” on page
13.Move the backup roller assembly shaft to the left and remove it from the right bushing.
14.Move the backup roller assembly to the right and out of the inner deflector and remove.
Note: When removing the backup roller assembly, use care not to damage the paper sensor flag.
Repair Information
