*Caution: The high-pressure spray from your pressure washer is capable of causing damage to surfaces such as wood, glass, automobile paint, auto striping and trim, delicate objects such as flowers and shrubs. Before spraying, check the item to be cleaned to assure yourself that it is strong enough to resist damage from the force of spray.

Changing Nozzles on Spray Wand

Danger: Risk of fluid injection. Do not direct discharge stream toward persons, unprotected skin, eyes or any pets or animals. Serious injury will occur.

warning: Flying objects could cause risk of serious injury. Do Not attempt to change nozzles while pressure washer is running. Turn engine off before changing nozzles.

1.Pull quick-connect coupler back and insert nozzle.

2. Release quick-connect coupler and twist nozzle to make sure it is secure in coupler.

Warning: Flying object could cause risk of serious injury. Ensure nozzle is completely inserted in quick-connect socket and quick- connect snap ring is fully engaged (forward) before squeezing gun trigger.

Chemicals and Cleaning Solvents

Applying chemicals or cleaning solvents is a low-pressure operation.

NOTE: Use only soaps and chemicals designed for pressure washer use. Do not use bleach.

To apply chemicals and solvents

1.

Press chemical hose (T) onto barbed

 

 

fitting located near high pressure hose

T

 

connection of pump as shown.

 

 

2.

Place the other end of chemical hose

 

 

with filter on it into the container holding

 

 

chemical/cleaning solution.

 

 

NOTE: For every 7 gallons (26.5 liters)

 

of water pumped 1 gallon (3.8 liters) of chemical/cleaning solution will be used.

3.Install low-pressure (black) nozzle into quick connect fitting of spray wand, refer Spray Wand Nozzles. NOTE: Chemicals and soaps will not siphon if the black soap nozzle is not installed on the spray wand.

4.After use of chemicals, place chemical hose into container of clean water and draw clean water through chemical injection system to rinse system thoroughly. If chemicals remain in the pump it could be damaged. Pumps damaged due to chemicals will not be covered under warranty.

Starting

Warning: To reduce the risk of injury, read the pressure washer instruction manual and the engine instruction manual before starting pressure washer.

DANGER: Risk of fluid injection and laceration. When using the high- pressure setting, DO NOT allow the high-pressure spray to come in contact with unprotected skin, eyes, or with any pets or animals. Serious injury will occur.

Your washer operates at fluid pressures and velocities high enough to penetrate human and animal flesh, which could result in amputation or other serious injury. Leaks caused by loose fit- tings or worn or damaged hoses can result in injection injuries. DO NOT TREAT FLUID INJECTION AS A SIMPLE CUT! See a physician immediately!

English

11

Page 11
Image 11
DeWalt N000589 Chemicals and Cleaning Solvents, Starting, Changing Nozzles on Spray Wand, To apply chemicals and solvents