DFI 915GM-MIGF user manual Jumper Settings, Clear Cmos Data, If you encounter the following

Hardware Installation

Jumper Settings

Clear CMOS Data

2

	1	2	3
	1-2 On: Normal
	(default)
	1	2	3
JP9	2-3 On:
	X Clear CMOS Data

If you encounter the following,

a)CMOS data becomes corrupted.

b)You forgot the supervisor or user password.

c)You are unable to boot-up the computer system because the processor’s clock/ratio was incorrectly set in the BIOS.

you can reconfigure the system with the default values stored in the

ROM BIOS.

To load the default values stored in the ROM BIOS, please follow the steps below.

1.Power-off the system and unplug the power cord.

2.Set JP9 pins 2 and 3 to On. Wait for a few seconds and set JP9 back to its default setting, pins 1 and 2 On.

3.Now plug the power cord and power-on the system.

If your reason for clearing the CMOS data is due to incorrect setting of the processor’s clock/ratio in the BIOS, please proceed to step 4.

21