G586OPC
54
Step 1
If you are connecting two hard drives, install the 40-pin
connector of the IDE cable into the primary IDE
shrouded header (1st IDE Connector). If you are adding
a third or fourth IDE device, install the 40-pin connector
of the other IDE cable into the secondary IDE shrouded
header (2nd IDE Connector).
Step 2
Install the other 40-pin header connector(s) into the
device with the colored edge of the ribbon cable aligned
to pin 1 of the drive edge connector(s).
Note:
Refer to your disk drive user's manual for information
about selecting proper drive switch settings.
The IDE Hard Disk Connector on the System Board