Dialogic DSI SPCI Network Interface Boards If a parameter is not required, it must be set to zero

Dialogic® DSI SPCI Network Interface Boards Programmer's Manual Issue 5

Mode			Required Parameters
	local st	local ts	source st	source ts	dest st	dest ts	pattern
1	*	*	*	*
2	*	*			*	*
3	*	*	*	*	*	*
4	*	*
5	*	*
6	*	*
10	*	*					*
11	*	*	*	*
12	*	*	*	*

If a parameter is not required, it must be set to zero.

local_stream

The local stream defines which local stream to use for all the modes of operation. The local streams are either an liu_id or a special identifier to allow connection to the signaling processor as follows:

	Local Stream	Connected to
0 ...	3	liu_id 0 ... 3
131	(0x83)	Signaling Processor

local_slot

The local slot defines which timeslot on the local stream to use for all the modes of operation. The local slot value has the following valid ranges depending on the type of local stream:

Local Stream Type	Local Slot Range
Local stream to E1 LIU	1 … 31
Local stream to T1 LIU	1 … 24
Local stream to signaling processor	0 … 3

mode

The value of the mode parameter determines which of the following operations to perform.

mode = 1 : Make a simplex connection from a timeslot on the CT bus to a timeslot on the local bus. Using parameters local_stream, local_slot, source_stream and source_slot, to specify the local and CT bus timeslots respectively.

71