Mounting Cup
Spring Clip
Tweeter
Tweeter Mounting
When flush or surface mounting tweeters, make sure the desired location can accommodate the hole size and depth required. Mount the cup using provided hardware (flush mount illustration shown on right.) Mount surface cup at desired angle with provided screws in tweeter mounting kit. Snake speaker wires through tweeter cup, connect tweeter to wires, and snap tweeter into cup by aligning the notches. Be careful not to push on the center of the tweeter grill.
Crossover Programming
Each D6 component set comes with a pair of model specific programmable crossovers. Under the cover there is a jumper marked “TWEETER” “REFERENCE” or “- 2dB” (See 
below). Tweeter attenuation can be achieved by removing the crossover cover and moving the jumper to the appropriate position. The REFERENCE position has no attenuation effect on the tweeter.
Tweeter Phase
When using as a component set with the tweeter mounted in a separate location, perfromance may be improved by switching the phase of the tweeter. This can be easily achieved by removing the crossover cover and moving the jumper inside the crossover marked “TWEETER PHASE” (See 
).
RAF Outputs
– IN + | – WFR + | – TWT + | – RAF + |
Each D6 component crossover has a third set of
outputs marked “RAF”(See 
). This stands for Rear Acoustic Fill. This output can be used to power an additional speaker off the same channel without affecting the impedance load on the source unit. This output provides
5
©2008 Diamond Audio Technologies. All rights reserved.
