Diamond Power Products 3100 Psi manual Add Engine Oil and Fuel

3.Place billboard (A) over holes on handle (viewing from front of unit). Push the tree clips (B) into the holes (C) until they sit flat against the billboard.

C

B

A

4.Insert spray gun holder wireform (A) through hole on left side of handle (viewing from front of unit). Hold wireform in place and attach a plastic knob (B) from inside of unit. Tighten by hand.

B

A

5.Insert “L” bolt (A) through hole just below billboard on right side of handle (viewing from front of unit). Hold bolt in place and attach plastic knob (B) from inside of unit. Tighten by hand.

B A

Add Engine Oil and Fuel

• Place pressure washer on a level surface.

NOTE: Verify provided oil bottle is the correct viscosity for current ambient temperature.

•Refer to engine operator’s manual and follow oil and fuel recommendations and instructions.

NOTICE

Any attempt to crank or start the engine before it has been properly filled with the recommended oil will result in equipment failure.

•Refer to engine manual for oil and fuel fill information.

•Damage to equipment resulting from failure to follow this instruction will void warranty.

NOTE: Check oil often during engine break–in. Refer to engine operator’s manual for recommendations.

7