DPLS1
Drain Panel Level
Sensor/Control
Installation Instructions
The DPLS1 Drain Pan Level Sensor / Control provides protection against drain pan overflow in Mitsubishi Electric Mr. Slim and CITY MULTI Indoor Units. The unit will sense a high condensate level in the drain pan. Should this occur the control shuts down the indoor unit before an overflow can occur. A thermistor error code will be produced should the DPLS1 activate indicating a fault which must be resolved before the unit will
This unit provides electronic overflow protection for Drain Pans in all Mr. Slim and CITY MULTI indoor units: MFZ, MS, MSY/Z, SEZ, SLZ, PCA/PCFY, PDFY, PEA/PEAD/PEFY, PKA/PKFY, PLA, PLKA/PLFY, PMFY, and PVFY.
Meets requirements as listed alternative to secondary drain pans in all indoor unit installations covered by the International Mechanical Code and adaptations.
DPLS1 – COMPONENTS
Control Box | Water Sensor | Splice Connector | M2 Wire Harness |
P Wire Harness | M1 Wire Harness |
Work Safe, READ THIS!
ATTENTION: FAILURE TO READ AND COMPLY WITH ALL WARNINGS, CAUTIONS AND INSTRUCTIONS PRIOR TO STARTING INSTALLATION MAY CAUSE PERSONAL INJURY AND/OR PROPERTY DAMAGE AND VOID WARRANTY.
This device must be installed in accordance with Equipment Manufacturer’s instructions and in accordance with all applicable local codes, including plumbing, drainage and electrical
The DPLS1 is powered by a
3400 Lawrenceville Suwanee Rd Suwanee, GA 30024
Tele:
Service:
1 | © 2011 Mitsubishi Electric & Electronics USA, Inc. |
