TransPort® WR44 Installation Guide
Page 12
TransPort® WR44 Installation Guide
Page 13
1. ASY Serial Port (3x) - Provides three additional asynchronous RS232 serial ports using RJ45 connectors.
2. SYN/ASYN Serial Port - Provides an X.21/RS422/RS232 synchronous / asynchronous serial port using a
DB25 connector.
3. GPS - Provides GPS capabilities using an SMA male connector.
4. ISDN - Provides an ISDN Basic Rate Interface (BRI) via an RJ45 port. This can be congured either
as a TE (terminal endpoint) or as NT-1 (network termination). The option also includes an additional
asynchronous serial port via a second RJ45 port.
5. Telemetry 1 I/O Interface - Provides 4 opto-isolated digital input ports and 1 opto-isolated digital output
port. It also provides a relay I/O port, a voltage monitoring port, and internal temperature monitoring.
6. Telemetry 2 I/O Interface - Provides 4 isolated analog I/O ports and 4 non-isolated digital I/O ports.
7. Fleet I/O Interface - Provides CAN and J1708 interface, GPS, 4 non-isolated digital I/O ports, ignition
sense port, and a 3 axis accelerometer.
8. PSTN - Provides a PSTN interface via an RJ45 connector that can be used to dial out and receive calls.
9. ISDN-U/PSTN - Provides an ISDN-U interface suitable for the USA plus PSTN interface. It can be
congured for Bell-103 modulation in leased line mode as well as a normal PSTN interface.
10. DialServ - This RJ11/FXS connection converts a PSTN analog modem to a RS-232 serial signal.
For more information on the Telemetry 1, Telemetry 2, and the Fleet I/O Interfaces please see the product specic
user’s guides which can be found at: http://ftp1.digi.com/support/documentation/transport/technicalnotes.htm
3 Installation

Mounting Tips

The TransPort WR44 should be positioned on a at, level surface or via a wall-mount, rackmount, or DIN rail
mounting brackets (see the Accessories section on page 22 for all options). The unit is designed for indoor use
(except for the WR44 R) and should be mounted in a location with adequate ventilation. Also, do not expose
the unit to extremes of heat or cold, strong magnetic elds, or liquids.
1
SIM 1
SIM 2
2
3
4
6
Step 1) (SIM card models only) - Install the SIM card(s): SIM card(s) should be inserted into SIM Sockets
as illustrated in the above Front View image. For SIM 1, the contacts should be face down. For SIM 2, the
contacts should be face up. In both cases, the end of the SIM card with the chamfered corner should be
inserted rst.
Note: For WR44-C models, not all networks require/support the use of Removable User Identity Modules
(R-UIM’s). If your service provider does not support R-UIMS, the unit may have been “provisioned” for use on
your chosen network before you receive it and this step of the installation procedure will not be required. If the
unit has not been provisioned, you will need to contact your service provider to obtain an “IMSI” and “NAI” in
order to provision the unit manually.
[Front of Unit]
[Rear of Unit]