Digicom Remote Videoalarm manual Technical Features, Smart Sensor

Vepro constantly controls the presence of sensors and videocameras and in case of alarm (generated by sensors), it captures the images coming before and after the alarm and sends them immediately to the control center to analyse the situation.

Vepro can be used also as a local videosurveillance system togheter with a specific storage unit equipped with an hard-disk.

In this way all the system can be remote viewed, at any time,through the EDGE connection or via LAN (for example through the ADSL router).

The surveillance center can display on the PC the events that caused the alarm or verify the live situation.

If a broadband connection is available (ADSL, UMTS), also the remote listening will be possible through the microphone on the videcamera.

TECHNICAL FEATURES

•Built-in Class 10 EDGE/GPRS communication device

•Built-in 54 Mbps Wi-Fi module

•Built-in 433 MHz receiver

•1 input

•1 output

•Management of I/O input for alarms and activations

•Mailing of Pre & Post alarm images

•Management of MJPEG images

•Images resolution: 640 x 480 pixel max

•Management of up to 4 Wi-Fi videcameras (54 Mbps)

•Management of up to 20 SMART sensors

•Anti-Tamper

•10/100 4 ports switch

•Internal Back-up Battery

•Built-in sound buzzer

SMART SENSOR

•433 MHz Wireless sensor

•Wired magnetic REED

•Vertical TILT sensor

•Sensors status check (magnetic and TILT) every seconds

•Alive message every 30 seconds

•Unique sensor via MAC address

•Battery low indication

•Long-Life battery (more than 1 year)

		EDGE/GPRS
		Control Center
IP Camera 300	Vepro	(MPEG-4)
		INTERNET

Smart Sensor

Images Storage Server

(FTP Server)

For further information visit our website http://www.digicom.it