Model 8/10 PLUS Introduction and Specifications

Description of Features

Outputs – Because switching is direct, the output will always have the same format as the selected input. Separate output connectors are provided for RGBS, S-Video, Composite Video, and Audio.

300 MHz Bandwidth – The wide bandwidth allows signals to be passed without loss of resolution. This is extremely important when using high resolution computer workstations.

Triple Action SwitchingTM (RGB Delay) – Triple Action SwitchingTM is a technique in which the RGB video is blanked for a brief period when a new input is selected. This prevents a distorted image from being displayed during the time the display device sync circuitry is locking onto the new sync input. When an input is selected, Triple-Action Switching® does this:

1.Drop the RGB video signals leaving sync connected.

2.Wait for 20 mS and then switch to the new sync signal.

3.Wait for the time delay set by the user (0.0 - 7.5 seconds) and then switch to the new RGB signals. (During this time the projector is setting up to match the new sync.)

Switcher Control – Each channel of the switcher can be controlled in any one of the following ways:

1.Front Panel Buttons.

2.Manual Remote Control Connector – KP-10 Wired Remote Control, IR-10 Infrared Remote Control or third party remote control.

3.RS-232 Control Connector – Provides for computer/serial control of the switcher.

Internal Power Supply – The Model 8/10 PLUS switchers have an internal, auto-switching (100 - 240 VAC, 50/60 Hz) power supply. The Model 8/10 PLUS switchers are UL, CE and CSA approved.

Rear Panel LED Indicators – Rear panel LEDs indicate which input is selected and which outputs are active.

The Model 10 PLUS front and back panels are shown below.

1

2

3

4

5

6

7

8

9

1 0

Extron • Model 8 PLUS & Model 10 PLUS Switchers • User’s Manual

Page 1-2

Page 7
Image 7
Extron electronic 10 PLUS, 8 PLUS user manual Description of Features