Aquatic Fitness System
2002 Owner’s Manual
Pump 1 Button: Press the button once to turn on Pump 1 to Low Speed. A second press will turn it to High Speed. A third press will turn the pump off. A
If the filter icon appears, a filtration cycle has begun and you will not be able to turn the pump off.
Pump 2 Button: Press the key once to turn on Pump 2. A second press will turn it off. A
Pump 3 Button: Press the button once to turn on Pump 3. A second press will turn it off. A
Light Button: Press this button to turn on the Aquatic Fitness System light; a second press will turn the light off. The Light Arrow Indicator will appear while the light is on. Some Aquatic Fitness System models have two lights controlled by this switch.
Temperature Set Button: Press the Up Arrow button to increase the desired temperature. Press the down arrow key to decrease the temperature. The temperature can be adjusted in 1°F increments from 59°F to 104°F (5°C to 40°). The new setting will remain on the display for 5 seconds as a confirmation.
Set Point Arrow Indicator: While you are adjusting the temperature, the Set Point Arrow Indicator will appear to let you know this is the desired temperature and not the actual temperature. After 5 seconds the display will return to the current temperature reading. When the temperature drops to 1°F below the set temperature, the heater will turn on until the temperature is 1°F above the set temperature.
The heater icon will appear while the heater is on and flash when there is a call for heat and the heater has not yet been activated.
Flashing Warning Lights: Three (3) Flashing Warning Lights will appear when problems have been identified. Refer to the Troubleshooting Guide for more information on what they mean and how to resolve the problem
Programming the Filtration Cycle
The filter cycle occurs twice a day (every 12 hours) and the duration is user programmable. Press and hold the light Key for approximately 5 seconds to display the current duration. Use the Temperature Set Keys to either decrease or increase the duration. The duration can be set from “0” (no filtration) to”12” (24 hours a day). Press the Light Key to save the new setting and to start the filtration cycle. The Filter Indicator will illuminate on the display under the filter icon during the active cycle.
To prevent overheating of the water, the filtration cycle will be suspended any time the temperature reaches
2°F above the set temperature. If the water cools to 1°F above the set temperature while the filtration cycle is still active (filter indicator flashing), the filtration cycle will reactivate. The filtration cycle will be suspended if the user enters the water and activates a pump motor manually. This is to prevent unnecessary operation of the ozonator. The cycle will be suspended for 40 minutes beyond the last manual activation of any accessory. The filter indicator will flash on the display while the filter cycle is suspended.
11
