Dimension One Spas Aquatic Fitness System Troubleshooting Guide, Heating System, Symptom, Problem

Aquatic Fitness System

Troubleshooting Guide

Troubleshooting Guide

Heating System

	Symptom		Problem			Corrective Action
	Does not heat		1.	Temperature setting is too low		1.	Turn up the thermostat
		2.		Dirty filter	2.		Clean filter
			3.	Flow switch out of adjustment		3.	Call for service
	Too hot	1.		Temperature setting is to high	1.		Turn down the thermostat
			2.	High limit tripped		2.	Call for service
	Flashing temperature of 34°F or	Possible temperature sensor failure				Call for service
	134°F appears on the display
Electrical System

	Symptom	Problem		Corrective Action
Will not turn on – in any mode		No power	Check circuit breaker and/or GFCI
Turns on by itself		Normal automatic daily power filtration, or		No action required
		anti-freeze cycle
Light is out		Burned out bulb	Replace bulb
Pump shuts down unexpectedly		1. Automatic 30-minute timer has shut		1. Push JETS pad again to start another
while in use		pump off			30-minute cycle
		2. Motor over-heated and automatic		2. If pump(s) will not restart when JETS
		protective device has shut down			pad is pushed, call for service
		pump(s)			Make sure that the equipment panel
					vent area is not blocked. Vent
					blockage can cause serious damage to
					your equipment.
	3 flashing LEDs appear on the Top	Possible sensor errors		1.	Check water level
Side Control			2.		Clean filter
				If problem persists:
					1.	Turn off power
					2.	Restart the system
				If problem persists:
					Call for service

27