2005 Triad II Specifications | Dimension One Spas |
2005 Triad II
Architectural Specification
R16 in [R41 cm]
R16 in [R41 cm]
16 in [41 cm]
Sequencer valve compartment
26 in [67 cm]
Recommended location for
Electrical Inlet
10 in [27 cm]
Hose Bib/
Water Drain
THIS 3 FOOT SQUARE AREA, ON BOTTOM OF SPA, TO BE SUPPORTED CONSISTENT WITH THE EDGES OF SPA BASE.
| 66 1/2 in [169 cm] |
| Shell |
16 in [41 cm] | See Caution |
| |
| 66 in [168 cm] |
| Skirt |
63 1/2 in [162 cm]
Pedestal
Base
Equipment Compartment
Control Panel Front Side of Spa
Vent | Vent | 25 1/2 in [64 cm] | Vent |
|
|
36 1/2 in [92 cm] 47 in [119 cm]
58 in [147 cm]
83 1/2 in [212 cm]
Control
Spa Lip
30 1/2 in [77 cm]
26 1/2 in [67 cm]
Hose Bib/ |
|
Water Drain |
|
| Pedestal Base |
3 1/2 in [9 cm] | Door Extends |
| Under Spa Lip |
67 in [170 cm]
83 in [210 cm]
Note: 1. Subject to change without notice.
2.Engineering specs may differ slightly from brochure.
3.For
4.Alternative cabinets may add significant weight. Ask your dealer for exact details
5.This is the approximate location for drilling a hole if you must bring the power line in through the bottom of the spa. Be careful not to puncture a plumbing line inside the equipment compartment(drill from the inside compartment out).
Caution:
Due to manufacturing tolerances there could be some
minor differences between the actual spa and the drawing above.
If site planning is critical to such tolerances, be sure to measure your actual spa.
| Specification, 2005, Triad II | Page 2 of 2 |