![](/images/new-backgrounds/1054381/5438131x1.webp)
Fireplace Installation
electric shock or injury to persons, always use a licensed electrician.
Ensure that the On/Off Switch is set to the Off position (refer to Operation section) and that the circuit on which the fireplace is to be installed has the power cut off at the service panel until installation is complete.
3.Lift fireplace and insert into opening. The fireplace's mounting trim should be flush against the wall (Figure 14).
4.Use bubble level (supplied) to level the fireplace within the framing. Adjust as required.
5.Drive four (4) supplied
Figure 14 | Mounting hole |
|
Wall surface
Mounting hole
mounting screws through the four (4) mounting holes located on the inside surface of the fireplace chassis, into wall studs (Figure 14).
6.Refer to Front Glass Installation section, page 16 for final installation procedures.
Front Glass Installation
1.Evenly distribute supplied glass rock on the front tray of the fireplace (Figure 15).
2.Carefully mount front glass assembly so that the front glass hooks (4) hang on the
front glass mounts on the
Figure 15
Front tray
Front glass assembly
16 | www.dimplex.com |