To operate, push the ON button to turn fireplace on, push the OFF button to turn the fireplace off.
Battery Replacement (FIGURE 6)
To replace the battery: |
| ||
1. | Slide battery cover open | Figure 6 | |
| on the hand held | On | |
| transmitter. | Button | |
2. | Install one | Off | |
| battery in the battery | ||
| Button | ||
| holder. | ||
| Battery | ||
3. | Close the battery cover. | ||
|
Remote Initialization | Battery |
In the event that your remote | Cover |
| |
control ceases to operate |
|
your fireplace, follow these |
|
steps to |
|
held transmitter and the remote control receiver in the fireplace: |
1.Place the Main ON/OFF Switch (Figure 5 A) in the OFF (“o”) position.
2.Wait a minimum of 5 seconds and then place the Main ON/OFF Switch in the Remote Control (“=”) position.
3.Within 10 seconds of changing the switch position, press the ON button located on the remote control transmitter (Figure 6).
This will synchronize the remote control transmitter and the fireplace receiver.
!NOTE: You will have only 10 seconds to perform this last step. Failure to do so will result in these steps needing to be followed again.
If you are still experiencing issues with your remote control, contact Dimplex North America Limited Customer Service at
9