Dimplex DF2550, DF2426GB, DF2426SS owner manual

minimum of 1875 watts. Option #3 - Hardwire

1.Wire a dedicated, properly fused circuit with 120 Volt, 15 Amp rating. Allow up to 8 feet of service cable for connecting power supply to junction box on fireplace when installing after finishing wall.

CAUTION: Use two conductor, non-metallic sheath cable with ground wire (3 wires total) for the incoming power supply on fireplace inserts. Use appropriate wire to meet local and national electrical codes for rated power consumption.

2.Remove the outer jacket and strip the individual conductor from the end.

3.Loosen the screw securing the junction box cover and remove the cover.

4.Take the cables out from the junction box, loosen the two wire twist nuts and remove the cord set. (Figure 3)

Figure 3 Figure 4

5.Route the power supply wire through the knockout on supplied alternative junction box cover and secure with a wire clamp (not supplied). (Figure 4)

6.Connect the black wire (live) from the unit to the black wire from

6