Dimplex DF2426SS, DF2550, DF2426GB owner manual Glass Cleaning, Fireplace Surface Cleaning

4.	Disconnect flicker from	Figure 8
	motor. (See Figure 7)
		Back
5.	Unscrew bulbs counter
		Ledge		Log Ember
	clockwise.
				Bed
6.	Insert new bulbs.
7.	Reconnect flicker to
	motor.	Rear		Front
8.	Replace the logset by	Tab	Side Section
	inserting the front edge			Edge
	of the log set and push
	down on the rear edge of the ember bed until it snaps into place.
	(Figure 8)

!NOTE: Ensure the logset is installed tightly under the back ledge to prevent light leakage.

9. Replace glass assembly.

Glass Cleaning

The front glass is cleaned in the factory during the assembly operation. During shipment, installation, handling, etc., the front glass may collect dust particles, these can be removed by dusting lightly with a clean dry cloth.

To remove fingerprints or other marks, the glass can be cleaned with a damp cloth. The glass should be completely dried with a lint free cloth to prevent water spots. To prevent scratching, do not use abrasive cleaners or spray liquids on the glass surface.

Fireplace Surface Cleaning

To remove fingerprints or other marks, the exterior finish can be cleaned with a damp cloth with a mild detergent. The surface should be completely dried with a lint free cloth to prevent water spots.

11