Figure 21 |
Log Driver |
Board |
7.Either pinch the clasp to release or cut each of the four
(4) mounting studs (one in each corner of the Log Driver Board) that attach the circuit board to the chassis of the firebox.
!NOTE: If mounting studs are cut, ensure they are replaced by those supplied with replacement board.
8.Clear both ends of mounting studs if cut.
9.Install replacement mounting studs (if necessary) by pushing them through the sheet metal from the outside of the firebox.
10.Properly orientate replacement Log Driver Board and push onto mounting studs until all four (4) snap closed.
10.Remove one wire terminal from original Log Driver Board and install onto replacement Log Driver Board, matching its original position.
11.Continue with remaining wire connections, moving one wire at a time, matching its original position.
WARNING: Improper
12.Once all connections are made, follow steps 1 and 2 in reverse order to reassemble the firebox.
19
