Dimplex Dimplex DFI2309 Remote Control Installation, Battery Installation/Replacement

The remote control has a range of approximately 50 feet (15.25 m). It does not have to be pointed at the fireplace and can pass through most obstacles (including walls). It is supplied with one of 243 independent frequencies to prevent interference with other units and the frequency designation is indicated on the back of the transmitter.

Replace battery when needed with a 9 volt battery.

Remote Control Installation

1.Plug fireplace cord set into the outlet located on the side of the receiver (Figure 2).

2.Plug receiver into the wall outlet.

3.Remove the plastic tag at the battery cover, to activate the remote control.

!NOTE: Fireplace Power On/Off Switch (Figure 1-A) must be in the On (“ I ”) position prior to using the Remote

Control.

ON/OFF Remote Control may be used to control most other electrical devices including TV’s, stereos and lamps.

CAUTION: For indoor use in dry areas only.

For use on electrical devices with 15 amp resistive load or 1/3 HP inductive load.

120 volt AC only.

!NOTE: The plug-in remote version may include either the remote transmitter as pictured on page 3 or the transmitter as shown to the right.

The following integrated remote control (Figure 3) is included with the models and MOD levels specified below:

Used in:

•DFI2309 MODs C to D

•DFI2310 MOD A2 to D

!NOTE: Ensure that the fireplace’s 3 Position On/Off Switch (Figure 1-B) is set to the remote control (“ II ”) setting.

Figure 3

On

Button

Battery

Off

Button

Battery Cover

To operate: push ON button to turn fireplace on; push OFF button to turn fireplace off (Figure 3).

!NOTE: Remote control operates main power supply. Heat must still be controlled by Low Heat and High Heat switches on fireplace (Figure 1-C & D).

Battery Installation/Replacement

1.Depress tab on the battery cover on the back of the remote transmitter and remove battery cover (Figure 3).

2.Properly orientate and install one (1) 12 Volt (A23) battery into the remote control.

3.Replace the battery cover.

Remote Initialization

1.From an power off position, place the Main On/Off Switch

(Figure 1-B) into the Remote (“ II ”) position.

2.Within 10 seconds of step 1, press the ON button on the remote control.

This will synchronize the remote control transmitter with the receiver within the fireplace.

!NOTE: You will only have 10 seconds to perform the last step. If this is not completed within 5-10 seconds, the procedure will have to be repeated.

4