REMOTE CONTROL USAGE (FIGURE 11)
The fireplace is supplied with a radio frequency remote control. This remote control has a range of approximately 25 feet. (17.5m), it does not have to be pointed at the fireplace and can pass through most obstacles (including walls).
FIGURE 11
Manual selection buttons
Level 3 indicator
Level 2 indicator
Level 1 indicator
Remote Control Initialization
This procedure is required every time there is a loss of power to the remote control in the fireplace. (i.e. power failure, breaker tripped, main power switch is turned off)
1.Ensure that power is supplied through main service panel.
2.Locate manual controls (refer to page 6).
3.Activate main power switch, red indicator light on the main power switch will illuminate.
4.Press ON button located on the remote control transmitter (FIGURE 1). This will synchronize the remote control transmitter and receiver.
Remote Control Usage
The remote control operates the fireplace levels sequentially. The level is increased every time the ON button on the transmitter is pressed. The fireplace can be turned off at any point by pressing the OFF button on the remote control transmitter.
Level 1: The flame effect is turned on and the first red indicator light illuminates.
Level 2: The flame effect remains on, the heater is activated to the low heat setting, and the first and second red indicator lights illuminate.
Level 3: The flame effect remains on, the heater is set to the high heat setting, and all three red indicators illuminate.
.
MANUAL SELECTION SWITCH
Operates fireplace in the same matter as the remote control transmitter. Pressing the - button has the same effect as the ON button on the remote control, and the O button has the same effect as the OFF button of the remote control. Pressing - once activates Level 1, twice activates Level 2, three times activates Level 3. Pressing O button turns the fireplace off.