NOTE
A 120 volt circuit is required. Additional appliances on the same circuit may exceed the current rating of the circuit breaker.
WARNING
Ensure the power cord is not installed so that it is pinched or against a sharp edge and ensure that the power cord is stored or secured to avoid tripping or snagging to reduce the risk of fire, electric shock or injury to persons.
Construction and electrical outlet wiring must comply with local building codes and other applicable regulations to reduce the risk of fire, electric shock and injury to persons.
Do not attempt to wire your own new outlets or circuits. To reduce the risk of fire, electric shock or injury to persons, always use a licensed electrician.
STOVE INSTALLATION
1.Make sure the units MAIN ON/OFF switch is switched OFF (refer to operating instruction section).
2.Plug the unit into a 15Amp/120volt outlet. If the cord does not reach, you may use an extension cord with a minimum rating of 120 volts, 8 amps, 18 gauge and approved for outdoor use.
OPERATION
To access the controls go to the back of the Stove.
A. MAIN ON/OFF SWITCH
The on/off switch supplies power to all unit functions (flame/towel warmer)
B. TOWEL WARMER ON/OFF SWITCH
The towel warmer on/off switch supplies power to the towel warmer. The main on/off switch must be on to activate towel warmer switch.
NOTE: When the Towel Warmer is switched ON, the warmer will operate. The warmer will not operate if the cooler insert is still in place within the unit.
Towel
Warmer
Main ON/OFF SwitchON/OFF
Switch
Figure 2
3
