EOS2006
If unit was operating prior to servicing allow at least 10 minutes for light bulbs and heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of electric shock or damage to persons.
POWER CORD REPLACEMENT
1.Open door by pulling the handles.
2.Remove the screw from the logset located in the center of the emberbed and remove the logset from the unit
3.While holding the mirror to prevent it from moving, remove the 2 mirror retaining bracket screws. Carefully remove the mirror and store in a safe place to prevent damage.
4.Remove the 3 screws securing rear reflector to the unit.
5.Remove the power cord wiring connections from the terminal block.
6.Remove the power cord ground wire from the ground terminal.
7.With needle nose pliers grasp the power cord strain relief grommet from inside the rear panel and push while twisting to remove.
8.Pull the power cord out through the hole in the rear cover.
9.Install the new cord set through the hole in the rear cover by placing the strain relief over the cord, hold the strain relief with pliers and slide into mounting hole.
10.Connect all of the wiring connections in their original locations.
11.Reassemble in the reverse order as above.
MAIN | WARMER |
11
