EOS2006
If unit was operating prior to servicing allow at least 10 minutes for light bulbs and heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of electric shock or damage to persons.
FLAME ROD AND MOTOR REPLACEMENT
1.Open door by pulling the handles.
2.Remove the screw from the logset located in the center of the emberbed and remove the
logset from the unit.
1.While holding the mirror to prevent it from moving, remove the 2 mirror retaining bracket screws. Carefully remove the mirror and store in a safe place to prevent damage.
2.Remove the 3 screws securing rear reflector to the unit.
3.Remove the reflector rod from the flame motor by pulling the end of the rod to the left and carefully remove flame rod from rubber sleeve.
4.Remove the 2 screws securing the flame motor to the flame motor bracket
5.Disconnect motor wiring connections from circuit board.
6.Discard the old motor.
7.Reassemble in the reverse order as above.
8
