DIMENSIONS
UNPACKING AND IMPORTANT NOTICES / INSTALLATION
SECTION 1
Unpacking and important notices
Contents
1 x Shower Unit
1 x Showerhead
1 x Flexible Hose
1 x Slider Rail Tube
1 x Slider Rail Brackets
Use of plumbers jointing compounds invalidates the guarantee.
Complete all plumbing connections before making any electrical connections.
The outlet of the shower unit must only be connected to the hose and showerhead supplied with the unit. Use of other
610mm
218mm
LOW AUTO
PRESSURE RESET
COLD
LOW
HIGH
STOP
TEMPERATURE
339mm
1 x Height adjuster
1 x Screw pack
1 x Soap dish
1 x Showerhead key
IMPORTANT NOTICES
PLEASE READ BEFORE ATTEMPTING
TO INSTALL THE SHOWER UNIT
1)The shower unit must be installed by a suitably qualified person and conform to IEE Regulations and National Water Council Bylaws.
2)The shower must only be connected to a 15mm mains cold water supply.
Do not connect the unit to the cold water supply of a header tank.
3)The minimum recommended running water pressure to which the shower heater may be connected is 15lb/sq in (1bar); running pressure of 8 litres/minute; maximum static pressure recommended 150lb/sq in (10 bar).
components will invalidate the warranty.
Always switch off at the isolating switch when the shower is not in use.
To comply with National Water Council bylaws a double check valve must be fitted where it is possible that the shower- head may come into contact with used water e.g. in the shower tray or bath.
Do not operate power tools in a wet envi- ronment. It is recommended that any power tools operated in the bath or shower area are supplied via a Residual Current Device (RCD).
WARNING! THIS APPLIANCE MUST BE EARTHED.
This shower is for connection to a
SECTION 2
Installation
Typical instantaneous electric shower installation
2
4)The shower unit must not be fitted where it may be exposed to frost, for example in an outdoor shower area. The shower must not be used if suspected of being frozen. Please note: Frost damage is not covered by the guarantee.
5)Do not use Plumbers jointing compound.
Double pole heater switch wall mounted in |
|
|
accordance with local authority regulations |
|
|
Seperate permanently |
|
|
connected supply |
|
|
from consumer unit |
|
|
Dimplex electric | Isolating |
|
water heater |
| |
stop tap |
| |
|
| |
| Cold |
|
| water |
|
| mains |
|
| supply | 3 |