Installation and Operating Instructions
Wall Fire SP4 Model No: SP420
Dimensions
(millimetres)
08/18887/1 Issue 1
Fig. 1
THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE.
Important Safety Advice:
When using electrical appliances, basic precautions should be followed to reduce the risk of fire, electric shock, and injury to persons, including the following :
•If the appliance is damaged, check immediately with the supplier before installation and operation.
•This heater must not be used if the front glass is damaged.
•Do not use this heater in the immediate surroundings of a bath, shower or swimming pool.
•Do not use outdoors.
•This heater must not be located immediately above or below a fixed socket outlet or connection box.
•Do not cover - Overheating will result if the heater is accidentally covered.
•In the event of a fault unplug the heater.
•Unplug the heater when not required for long periods.
•Although this heater complies with safety standards, we do not recommend its use on deep pile carpets or on long hair type of rugs.
•Do not leave young children, the elderly, or the infirm unsupervised in the vicinity of the heater.
•The appliance must be positioned so that the plug is accessible.
•If the supply cord is damaged it must be replaced by the manufacturer or service agent or similarly qualified person in order to avoid a hazard.
Electrical
WARNING – THIS APPLIANCE MUST BE EARTHED
This heater must be used on an AC ~ supply only and the voltage marked on the heater must correspond to the supply voltage.
Do not switch the appliance on until properly installed. Please read all the safety warnings and operating instructions.
General
Unpack the heater carefully and retain the packaging for pos- sible future use, in the event of moving or returning the fire to your supplier.
Contents of Carton.
•SP4 Heater.
•Wall fixing bracket.
•Six fixing screws and six wall plugs.
•Remote control and batteries ( 3 AAA’s type).
•Spare bulb.
Do not connect the heater to an electricity supply until it is installed on a wall correctly. - see ‘Installation’.
When in operation there is a 300 watt heat output from the fuel effect, and an additional 120 watt output when the heated glass panel is in operation.
The heater can be used remotely or manually. - see ‘Opera- tion’.
General features of remote control are:
•Activate/Deactivate heated glass panel.
•The illumination of fuel effect can be increased or decreased.
•Programmable timer.
Please note: Used in an environment where background noise is very low, it may be possible to hear the motor which oper- ates the flame effect. This is normal and should not be a cause for concern.
