Lamp Replacement
WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE REMOVING LAMPS.
The front surround will need to be removed in order to change lamps.
Warning
The front surround is fixed with 4 spring loaded pins and is supported at the top by the chassis.
To gain access to the lamps please apply the following proce- dure:
While holding the surround by its sides with both hands, care- fully pull forwards the surround at the bottom until the pins detach from the clips (see Fig. 9).
Spring clip
Holding Pin
Fig. 9
When the bottom holding pins are undone, carefully pull for- wards at the top until the top pins detach and then lift the surround up and out (see Fig. 10).
For access to the bottom bulbs, carefully slide the flexible ro- tisserie to one side ensuring that the rubber grommets are not lost (see Fig 11).
Rotate flexible
Rotisserie out of position
Grommet
Fig. 11
Remove the defective lamp by unscrewing it (see Fig 12). Replace with a 60W E14 SES clear candle bulb, rotating it. Take care not to over tighten the bulb.
Flexible Rotisserie rotated out of position
Chassis bracket
|
|
|
| Fig. 12 |
Chassis |
|
| To refit the surround back to the chassis: | |
|
|
| 1. | Refit the rotisserie making sure that the rubber grom- |
|
|
| mets are carefully pushed back into the slotted holes on the | |
|
|
| axial brackets (see Fig 11). | |
|
|
| 2. | Place the surround on the chassis bracket and align |
Spring clip | Holding |
| the pins with the spring slots. Make sure the surround is the | |
| correct way up with the cut out for switches at the bottom (see | |||
| Pin | Fig. 10 | Fig 10). | |
|
| 3. | Push firmly at each corner of the surround where the | |
|
|
| ||
pin is located until it clips back into position.
