TWEETER INSTALLATION
Review the Installation Precautions section of this guide before proceeding.
Flush Mounting into Mounted Panels
Note: Use either the standard mount housing or the angled mount housing.
1.Determine the tweeter mounting location, then route the wires from the crossover to the tweeter location.
2.Mark the center point of the tweeter location.
3.If using a hole saw, first drill a pilot hole, then cut out the hole using a standard
4.If not using a hole saw, use either the cardboard packaging for the tweeters or the surface mount trim ring as a template to mark the proper size hole. Cut out the hole.
5.Remove the tweeter grill, and the remove the tweeter from the surface mount housing using the tweeter tool (turn CW). Insert the proper length machine bolt through the housing and connect to the metal mounting bracket. (See Figure 2.)
6.Connect the speaker wires observing the correct polarity.
7.Press the metal bracket portion of the assembly through the hole.
8.Screw the bolts in until the tweeter housing is firmly mounted to the panel.
9.Insert the tweeter into the housing and use the tweeter tool and rotate the tweeter CCW till locked. Attach the tweeter grill.
FIGURE 2—FLUSH MOUNTING REMOVED PANELS
Grill Tweeter
BoltsPanel
Bracket
Tweeter Tool
Tweeter | Flush Mount | Wiring |
Wire | Housing |
|
6 | © 2004 Directed Electronics, Inc |
