Tweeter Surface Mounting
Note: Use either the standard mount housing or the angled mount housing.
1.Determine the tweeter mounting location, then route the wires from the crossover to the tweeter loca- tion.
2.Remove the tweeter grill, and the remove the tweeter from the surface mount housing using the tweeter tool (turn CW). Place the surface mount housing against the panel and mark the two holes at the rear of the housing.
3.Drill the smaller
4.Drill a larger center hole using a 3/8" drill bit, insert a grommet and
route the speaker wire from the crossover through the grommet.
5.After removing the surface mount tweeter assembly, route the tweeter wires through the larger hole in the housing and connect to the speaker wires from the crossover. (See Figure 4.)
6.Insert the excess speaker wire into the hole and position the housing so the housing will not pinch the wires after final mounting.
7.Attach the housing using the supplied screws of the correct length for a solid mount.
8.Insert the tweeter into the housing and use the tweeter tool and rotate the tweeter CCW till locked. Attach the tweeter grill.
FIGURE 3—TWEETER SURFACE MOUNTING
Grill
Tweeter
Mounting | Surface Mount Housing | |
Screws |
| |
|
|
|
Tweeter | TWEETER | Tweeter |
Tool |
| Wiring |
PanelWiring
© 2004 Directed Electronics, Inc | 7 |
