INSTALLATION PRECAUTIONS

The Directed SX series neodymium sepa- rates are designed for installation into factory speaker locations, custom mounting enclosures or any flat mounting surface inside the vehicle. The following precautions and instructions cover the basic and most common types of installa- tion.

„Check behind panels for clearance of metal brackets, hoses, and wire harnesses before making any cuts.

„When mounting speakers into doors, roll the window up and down to check clearance of the glass and window regulator.

„Make sure the mounting holes are the correct size for the speaker. Undersized holes can cause speaker

distortion or shorting of the speaker leads to the chassis ground. Over- sized holes will not allow the mounting screws to make sufficient contact with the panel, allowing the speaker to become loose.

„Always protect the wires when routing by avoiding sharp metal edges, moving parts such as heater or vent controls, clutch pedals, brake pedals, steering columns, and power window motors and gears.

„When routing wires through metal panels and doorjambs always use vinyl tubing and grommets for protection and a professional-looking installation.

TWEETER CROSSOVER INSTALLATION

Note: The Black/White wire is the posi- tive (+) audio wire.

1.There are provided two crossover assemblies, one for each tweeter.

2.After the tweeter locations have been determined. Route the wiring from the OUT side of the crossover and connect it to the tweeter wiring. Ensure you observe polarity of wires during wiring.

Note: Shut power off to amplifier prior to completing the next step.

3.The IN side of the crossover is connected to the amplifier. Ensure you observe polarity of wires during wiring.

4.Wire tie the crossover assembly and the crossover wiring to existing vehicle cabling.

© 2004 Directed Electronics, Inc

5

Page 5
Image 5
Directed Audio CSX-T owner manual Installation Precautions, Tweeter Crossover Installation