
Two DW4020 installation methods
There two ways to install the DW4020.
•If an analog phone line is available, assemble and install the system using the instructions in Installing the system using a modem on page 11. This method is preferred and is usually the one that will be used.
•If no analog phone line is available, you must configure the DW4020 through the serial port. Follow the instructions in Appendix C.
Summary of DW4020 installation process
DW4020 installation is a
1.Assemble the DW 4020 components.
2.Connect the DW4020 to the installer PC Ethernet and power up the DW4020. Use surge protectors.
3.Connect the installer PC via USB and run Websetup to establish operating parameters and commission.
4.Register the customer and select subscription options via Websetup.
5.Record site ID and assigned IP address(es) for the customer on the cover of the User Guide.
6.Transfer of parameter information to Gateway Host; Exit Websetup.
7.Assemble and install the satellite antenna. Run cables from the outdoor components to the indoor equipment. Clearly label the receive and transmit coaxial cable at the antenna, ground block, and indoor units connectors.
8.Complete pointing and ACP.
9.Disconnect installer PC and connect the Gateway to the receive modem with the USB cable. Connect the customer computer equipment to the Gateway via Ethernet cable.
10.Verify customer operation, information recorded on User Guide cover, and receive and transmit cable labeling. Optional: assist in customer computer configuration.
Antenna installation The DW4020 can be used with the HNS DW4000 74cm
6
Chapter 2 • Installing the indoor equipment