Post-commissioning

In post-commissioning, you peak the satellite signal, attach the DW4020 to the customer computer that has a functioning Ethernet interface, and confirm the customer can surf the Internet.

Peak the satellite signal 1. Unplug the DW4020 power cord from the wall outlet or surge protector.

2.Remove the phone line and network cable from the installer laptop PC.

3.Remove the network cable from the Gateway and unplug the USB cable from the receive modem.

4.Connect a long USB cable from the back of the receive modem to the installer laptop PC.

5.Assemble and install the satellite antenna.

6.Place the outdoor pointing interface (OPI) in the receive cable line if applicable.

7.Power on the DW4020.Select StartProgramsDIRECWAY InstallerAntenna Pointing. The Antenna Pointing - Antenna Location screen appears. See Figure 25.

8.Verify the ZIP code matches the antenna location and select

Next. The Antenna Pointing - Receiver screen appears. Check the Longitude, Hemisphere, and Frequency values. See Figure 26.

Figure 25: Antenna Location; verify ZIP code

Chapter 2 • Installing the indoor equipment 1031484-0001 Revision 2

27

Page 39
Image 39
Hughes DW4020 manual Post-commissioning, Verify the ZIP code matches the antenna location and select