Gateway LEDs not lit If the Gateway does not seem to be functioning and its LEDs are not lit, and the receive modem READY LED blinks as shown in Figure 68, take the following steps.

Check to make sure the power cord is securely attached to the Gateway and receive modem and plugged into the wall outlet or surge protector. See Figure 66. If the power cord was loose, the Gateway and receive modem READY LEDs will come on when power is restored.

If securing the power cord does not solve the problem, check all cable connections. Tighten any that seem loose.

If the Gateway READY LED still does not come on, power cycle the DW4020 by unplugging the power cord from the wall outlet or surge protector, waiting ten seconds, and plugging it back in.

If the problem persists, contact technical support.

Receive modem READY

LED blinks

Gateway LEDS are not lit

Figure 68: Gateway LEDs not lit

Appendix C • Installing the DW4020 Manually 1031484-0001 Revision 2

91

Page 103
Image 103
Hughes DW4020 manual Gateway LEDs not lit