Hughes DW4020 manual Installation checklist, Appendix E, Installation summary and checklist

Appendix E

Installation checklist

Installation summary and checklist

The following DW4020 components are installed:

•Antennas (outdoor unit or ODU)

•Coaxial cable (IFL)

•DW4020

The main tasks required to install an DW4020 are summarized below. For Web commissioning, the customer should have an analog phone line and a functioning Ethernet interface.

Assemble the DW4020 components. These consist of the receive and transmit modems, and the Gateway.

Connect the DW4020 to installer laptop PC Ethernet and power up DW4020.

Connect the installer laptop PC via USB and run Websetup to establish operating parameters.

Register the end user and select subscription options via Websetup.

Record site ID, Gateway IP address, subnet mask, and service offering on cover of User Guide.

Transfer of parameter information to Gateway. Exit Websetup.

Assemble and install the satellite antenna. Run cables from the outdoor components to the indoor equipment. Clearly label the receive and transmit coaxial cable at the antenna, ground block, and modem connectors.

Complete antenna pointing and auto cross-polarization (ACP).

Disconnect installer laptop PC and connect the Gateway to the receive modem with USB cable. Connect the customer computer to the Gateway via Ethernet cable.

Verify customer operation, information recorded on User Guide cover, and receive and transmit cable labeling. Optional: assist in customer computer configuration.

Appendix E • Installation checklist 1031484-0001 Revision 2

121