Hughes DW4020 manual Installing the indoor equipment, Customer installation requirements, Chapter

Models: DW4020

1 136
Download 136 pages 42.39 Kb
Page 17
Image 17
Installing the indoor equipment

Chapter 2

Installing the indoor equipment

System pre-installationTogether, the receive modem, the transmit modem, and the Gateway are called the DW4020 and sometimes referred to as the

indoor unit (IDU). The receive modem is also called the IRU; the transmit modem is also called the ITU; and the Gateway is sometimes called the GWH.

The three units must be stacked correctly to ensure proper heat dissipation. The receive modem must be installed on top of the transmit modem, which is in turn installed on top of the Gateway. See Figure 10 on page 15.

Installation PC requirements The installer laptop PC must fulfill the following requirements:

USB port

Ethernet

Dial-out modem

Windows 98 or higher, with DHCP configured to automatically accept IP addresses. See Appendix D.

Websetup installed. See Installing DIRECWAY installation software on installer laptop on page 8.

Customer installation requirements

The customer must have:

A functioning Ethernet interface installed on at least one computer. This is not necessary to commission the DW4020, but you must ensure the customer can surf before you leave.

Ethernet cables; as many as there are computers that will connect to the DW4020.

An analog phone line.

Chapter 2 • Installing the indoor equipment 1031484-0001 Revision 2

5

Page 17
Image 17
Hughes DW4020 manual Installing the indoor equipment, Customer installation requirements, Chapter