Normal operation, data being sent and received
During normal DW4020 operation, the modems’ READY LEDs are continuously lit, the RX and TX LEDs blink as they pass data, and both the Gateway LEDs are continuously lit, as shown in Figure 64.
RX LED blinks as modem passes data; READY LED on continuously
TX LED blinks as modem passes data; READY LED on continuously
Gateway STATUS and READY LEDs continuously lit
Figure 64: Normal operation, data being sent and received
Problem: receive modem READY LED not on
If the DW4020 is not operating normally and the receive modem’s READY LED is not lit, as shown in Figure 65, take the following steps:
•Check to make sure the power cord is securely attached to the receive modem and plugged into the wall outlet or surge protector. See Figure 66. If the power cord was loose, the receive modem READY led will come on when power is restored.
•If securing the power cord does not solve the problem, check all cable connections. Tighten any that seem loose.
•If the Receive modem READY LED still does not come on, power cycle the DW4020 by unplugging the power cord from the wall outlet or surge protector, waiting ten seconds, and plugging it back in.
•If the problem persists, contact technical support.
Note: Often, if the receive modem READY LED is not lit, the other modem LEDs will not be lit either.
88
Appendix C • Installing the DW4020 Manually
