
Configuring Boot Parameters
Use Configure Boot Parameters to configure the Gateway for outroute reception and downloading of software. For initial installation, most parameters must be entered, except for VSAT Return Path, which is always “Inroute.”
Thus, you will need your installer ID, and you will need all necessary information to enter data for the fields marked with an asterisk in Figure 80. One asterisk means the installer must provide or obtain the information; two asterisks means the information is global for all installations. Refer to Appendix A for information on how to determine how to convert degrees/decimal values to degree/minutes values.
Note: Two good Web sites for determining your latitude and
longitude include: http://www.zipinfo.com/search/zipcode.htm and
Note: If you will be using the Outdoor Pointing Interface (OPI) device, remember that the LNB 22KHz Switch parameter must be set to "OFF" to enable the device. You may leave the parameter at OFF for the rest of the installation. The instructions below describe how to set parameters.
1.Enter a at the Main Menu prompt. Each parameter shown in Figure 80 appears, one at a time, one line at a time.
For example, the first parameter to appear after you enter a is the VSAT Return Path Parameter, as shown in Figure 79.
.
VSAT Return Path (1 = Receive Only, 2 = Inroute, 3 = LAN) <2>:
Figure 79: VSAT Return Path Parameter
All the parameters are shown in the Display Current Configuration screen in Figure 80. The screen is displayed by entering b at the Main Menu prompt.
Appendix C • Installing the DW4020 Manually